2
5. USB Connector 2-19
Specifications
Transferring Screen Data
Screen data can be transferred via USB-miniB (USB slave port).
Be sure to install the dedicated USB driver for the TS series on the computer. For the installation
procedure, refer to “Installation Procedure of the Driver for Screen Data Transfer” on (page 2-19).
Connection Example
*1 Use a commercially available USB cable. You are recommended to use a shielded twist-pair USB cable of
5 m in length.
Installation Procedure of the Driver for Screen Data Transfer
• For Windows Vista/7/8
1. Connect the USB-mini B port of the TS series (with power on) to the computer (with power on)
using a USB cable.
2. The USB driver is automatically installed. During installation, the following message is
displayed on the computer's taskbar.
3. The following message is displayed on the computer's taskbar when installation is finished.
If installation has terminated due to an error, reinstall the USB driver. See page 2-21.
- When successfully completed
- When terminated due to error
USB-A
USB-miniB
TS
Computer
USB cable
*1
To Next Page
Loading...
