4
1. Coin-type Lithium Battery 4-3
Handling of TS Series Components
Battery Replacement Procedure
1. Make a backup copy of data stored in the SRAM area.
For backing up procedure, refer to “SRAM Area Backup Procedure” (page 4-2).
2. Turn off the TS unit.
3. Lift and remove the cover of the battery holder according to the arrows marked in the figures
below.
4. Press the detent on the right of the battery in the direction of the arrow.
5. When the right side of the battery rises, insert a finger under the battery as indicated by the arrow
and take it out.
6. Slide a new battery with the “+” side of facing upward, to the left into the battery holder. Press the
right side of the battery until it clicks.
DANGER
Electric shock hazard
Turn off the power to the TS series before performing steps 3 through 7 below.
Rear view
Example: TS1070
Battery
Detent
To Next Page
Loading...
