4-4 1. Coin-type Lithium Battery
7. Insert the detent on the underside of the battery holder cover into the TS unit. Press the top of the
cover until it clicks.
8. Turn on the TS unit. Go to the Main Menu screen and press the [Press this switch after battery
replacement.] switch.
The following confirmation dialog appears. Press [Completed].
* If not replacing with a new battery, press [Cancel].
9. Check that the [Press this switch after battery replacement.] switch and the message “Battery
changeover required” are cleared from the bottom of the Main Menu screen.
10. When a backup file “∗.RAM” is saved, transfer it to the TS series.
CAUTION
If the [Completed] switch is pressed though no new battery is set, no power will be
supplied to retain the clock time and SRAM.
Finish replacing with a new battery before pressing [Completed].
To Next Page
Loading...
