Common Service Settings
141
Tools
5
îš„Same as Side 1
Prints in the same position as the front side.
îš„Mirror Side 1
Prints in a position symmetrically opposite to the front side.
Other Settings
You can make other settings relating to the machine itself.
Fax Service
Switches between the Fax and Server Fax features.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The Fax and Server Fax features cannot be enabled at the same time.
îš„Scan to Fax
Allows you to use the Fax feature on the machine.
îš„Scan to Fax Server
Allows you to use the Server Fax feature on the machine.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Offset Stacking (Center Tray)
Offsetting means that each set (copies) or each job is delivered at a slightly shifted output
position from the output position of the previously output set or job. If the previous copy set is
output to a front position on the tray, the next copy set is output to a back position on the tray.
Set the operation of the offset feature for the center tray.
Offset Stacking (Center Tray - Upper)
Offsetting means that each set (copies) or each job is delivered at a slightly shifted output
position from the output position of the previously output set or job. If the previous copy set is
output to a front position on the tray, the next copy set is output to a back position on the tray.
Set the operation of the offset feature for the upper center tray.
Offset Stacking (Center Tray - Lower)
Offsetting means that each set (copies) or each job is delivered at a slightly shifted output
position from the output position of the previously output set or job. If the previous copy set is
output to a front position on the tray, the next copy set is output to a back position on the tray.
Set the operation of the offset feature for the lower center tray.
Offset Stacking (Right Middle Tray)
Offsetting means that each set (copies) or each job is delivered at a slightly shifted output
position from the output position of the previously output set or job. If the previous copy set is
output to a front position on the tray, the next copy set is output to a back position on the tray.
Set the operation of the offset feature for the finisher tray.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
îš„No Offset
No offset output.
îš„Offset per Set
Offsets the output position for each set of copies.
To Next Page
Loading...
Need help?
General
