3 Maintenance
60
Maintenance
3
5
Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6
Return the staple cartridge to its original
position.
7
Close the front cover of the finisher.
Note • If the front cover of the finisher is not completely closed, a message will appear and the
machine will not operate.
Replacing the Staple Cartridge (for Finisher-B1)
When the Finisher-B1 (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the front cover of the finisher.
2
Hold the staple cartridge by Lever R1 and
pull the staple cartridge holder to the right.
1
2
To Next Page
Loading...
Need help?
General
