5 Tools
170
Tools
5
îš„Attribute Type of Fax Number
Set the fax number attribute type. Up to 32 characters are allowed.
îš„Attribute Type of E-mail (Internet Fax)
Set the Internet fax address attribute type. Up to 32 characters are allowed.
îš„Attribute Type of Custom Item 1, 2, and 3
Set the LDAP attribute type of custom items 1 to 3. Up to 32 characters are allowed.
îš„Attribute Name of Custom Item 1, 2, and 3
Set the attribute names assigned to custom items 1 to 3. You can enter up to 16 characters.
îš„Attribute Type of Certificate
Set the certificate attribute type. Up to 32 characters are allowed.
îš„Maximum Number of Search Results
Set the upper limit on the number of searched address results from 5 to 100. If there are more
search results than the upper limit, the search operation is stopped at that number.
îš„Search Time-Out
Select whether or not to set a search time-out. Set the value from 5 to 120 seconds in 1
second increments.
îš„Directory Service for Address Book
Select whether to use an address book stored on the directory server.
Even when [Enabled] is selected, unless the following conditions are satisfied, the address
book of the directory server will not be started.
z
The IP address of the directory server (primary) of the machine must be set
z
The IP address or Internet address of the directory server (primary) must be set
z
The port numbers used for LDAP communication must be set on the directory server and the
machine
SMB Server Settings
îš„SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP Address]
for each of SMB servers 1 to 5.
îš„Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory.
Important • Use the NetBIOS or Active Directory domain name for the domain name.
îš„Server Name/IP Address
Enter the server name or IP address.
This setting is effective when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
Important • Use the NetBIOS computer name or full computer name with DNS suffix for the server
name.
Important • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Set the SSL/TLS.
To Next Page
Loading...
Need help?
General
