5 Tools
158
Tools
5
îš„Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
îš„Adobe Communication Protocol
z
Normal
Select this when the communication protocol is in the ASCII format.
z
Binary
Select this when the communication protocol is in the binary format. Depending on the data,
the print job may be completed faster than when Normal is selected.
z
TBCP
Select this to switch between the specific control codes when the communication protocols
involve both ASCII and binary formats.
îš„Bi-directional Communication
Specifies whether to allow bi-directional communications.
USB
îš„Port Status
Select [Enabled] to use a USB interface.
îš„Print Mode
Configure the print language on the machine to match the received data.
Select [Auto] to set the device so that it will automatically determine and use the most suitable
language to print data received from the host device.
îš„PJL
Enable when receiving a job using PJL commands.
îš„Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
îš„Adobe Communication Protocol
z
Normal
Select this when the communication protocol is in the ASCII format.
z
Binary
Select this when the communication protocol is in the binary format. Depending on the data,
the print job may be completed faster than when Normal is selected.
z
TBCP
Select this to switch between the specific control codes when the communication protocols
involve both ASCII and binary formats.
z
RAW
Select this when the communication protocol is in the RAW format.
If you cannot correctly print EPS files from a Macintosh computer via USB, select this option.
LPD
îš„Port Status
Select [Enabled] to use LPD.
îš„LPD Port Number
Select [Standard (515)] or [Enter Number].
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 515.
To Next Page
Loading...
Need help?
General
