14 Problem Solving
428
Problem Solving
14
018-794
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "94" (no more results) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-795
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "95" (results remaining) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-796
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "96" (client loop detected) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
018-797
O [Cause] LDAP server protocol error caused by the Address Book
operation. The server returned RFC2251 Result Message
No "97" (referral limit exceeded) for Address Book query.
[Remedy] Have the network administrator check the LDAP server
status.
024-700
O O O O [Cause] Required memory capacity or hard disk is not installed to
use the optional feature.
[Remedy] Turn off the power, wait until the touch screen goes dark,
and then turn on power again. If the error persists, contact
our Customer Support Center.
024-742
O [Cause] Booklet printing was specified for printer properties, but
the number of print pages for the job exceeded the
maximum number for booklet creation.
[Remedy] Change the printer properties setting to split the pages
appropriately to create separate volumes, or to cancel the
booklet setting.
024-746
O [Cause] The specified paper type is not compatible with the
specified paper size, paper tray, output tray, or 2-sided
printing.
[Remedy] Check the print data.
024-747
O [Cause] Incompatible print parameters are used. The combination
of the specified features such as Document Size, Paper
Size, Paper Tray, 2 sided print, and Output Tray is
incompatible.
[Remedy] Check the print data, and try to print again.
024-748
O [Cause] The number of digits specified in [Number of Digits] of the
[Page Number] screen does not match the value specified
in [Starting Number] of the [Apply Page Numbers To]
screen.
[Remedy] Set [Number of Digits] to [Auto Assign] or a value
appropriate for the value specified in [Starting Number].
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
