Fuji Xerox ApeosPort-VII C3321 - Page 302

13 Advanced Settings
302
[Port 9100]
 [Port Status]
Select [Enabled] to use Port 9100.
Select this option when the communication protocol is in the RAW format for Windows
Standard TCP/IP port monitor.
 [Port Number]
Enter a port number for Port 9100.
Important

Do not use the numbers assigned to the other ports.
[SNMP]
 [Port Status]
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the device on the network.
[FTP Client]
 [Port Status]
Select [Enabled] when you use the [Scan] service with FTP transmission.
Note

Select a communication mode to send data scanned via FTP. [Passive Mode] is selected by factory default.
You can change the setting from CentreWare Internet Services.
[Receive Email]
 [Port Status]
Select [Enabled] when you receive emails or Internet faxes.
[Send Email]
 [Port Status]
Select [Enabled] when you send emails or Internet faxes.
[Email Notification Service]
 [Port Status]
Select [Enabled] when you use the Email Notification Service.
The Email Notification Service notifies you of the device status or the completion of a print
job and a direct fax job by email.
Note

[Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status], [Interlock
Status], and [Fault Notice] are notified as the device status.

You can configure the Email Notification Service in CentreWare Internet Services. For more information, refer
to the help of CentreWare Internet Services.
[UPnP Discovery]
 [Port Status]
Select [Enabled] to use UPnP.