Emulation
481
Matrix 2 of 5
Forms
You can use ESC/P to register forms.
The following shows the number of forms you can register.
When the number of registered forms already has reached the upper limit or when the full capacity assigned
for forms is full, attempting to register a new form will fail. In this case, any error will not be notified.
Setting Menu Items Related to the ESC/P Mode
[Port Settings]
Set the port used in emulation modes under [Device] >[Connectivity & Network Setup] >
[Port Settings]
Port Status (LPD/IPP/USB-/Port 9100)
Enables the ports to be used in the ESC/P emulation mode.
[USB - Print Mode]
Sets the print mode of the USB port so that it can be used by ESC/P emulation. Select
[ESC/P] as the print mode.
[USB - Print Mode] sets the method of processing data received from host interfaces. If this is set to [ESC/P]
here, the device will not switch languages automatically as described in "Switching between Printer
Languages" (P.479).
The print mode can also be specified for each protocol (LPD, IPP, Port 9100, or WSD) from CentreWare
Internet Services.
[Delete Form]
[Device] > [App Settings] > [Print Settings] > [Delete Form] allows you to delete forms
registered with the device.
ESC/P
Storage not installed 64
Storage installed 64
To Next Page
Loading...
Need help?
General
