Emulation
483
Extended Settings
Paper size 2 Sets the size of paper to be printed. This setting can be made only when
[Paper Tray] is set to [Auto] or [Tray 5]. This setting can be configured only for
cut sheets.
[4]: A4
[5]: A5
[15]: B5
[21]: 8.5 x 14
[22]: 8.5 x 13
[23]: 8.5 x 11
[0]: Postcard
When [Tray 1], [Tray 2], [Tray 3], or [Tray 4] is set for [Paper tray], [Paper size]
cannot be set.
When [Preset%] or [Fit to Cut Sheet] is selected for [Reduce/Enlarge], the device
automatically calculates the magnification based on a combination of [Original
Size] and [Paper Size]. If the magnification, however, is outside the range of 45-
210%, the document will not be reduced/enlarged, and will be printed at a scale of
100%. When [2 Up] is selected, the device automatically calculates the
magnification based on a combination of [Original Size] and 1/2 of [Paper Size].
Setting Item Item Number Value
Paper position 20 [0](Default): Without cut sheet feeder (left)
[1]: With cut sheet feeder (center)
When [Without cut sheet feeder (left)] is specified and FF (line feed command) is
received, the device skips the number of lines specified in VFU. When [With cut
sheet feeder (center)] is specified, the device inserts a page break.
When a continuous form paper is selected for [Original Size], [Paper Position]
cannot be set.
Output quantity 8 [1 to 250] (Default: 1): 1-250 copies
When the output quantity is specified by a client, that number of copies is printed.
After printing, the number set on the control panel is overwritten with the number
newly specified. However, the number of copies specified from the LPD port will
not overwrite the number set on the control panel.
Setting Item Item
Number
Value
To Next Page
Loading...
Need help?
General
