EasyManua.ls Logo

Fuji Xerox ApeosPort-VII C7788

Fuji Xerox ApeosPort-VII C7788
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Copying Procedure
101
3 If the previous settings still remain, select [Reset].
4 Configure each feature as necessary.
Step 3 Entering a Quantity
You can enter up to 9999 sets.
Step 4 Starting the Copy Job
The following describes how to start a copy job.
1 Select [Start].
Important
z
If the document has been loaded in the document feeder, do not hold down the document while it is being
conveyed.
Note
z
If a problem occurs, an error message appears on the touch screen. Follow the instructions of the message to
solve the problem.
z
You can set the next job during copying.
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2 Select [Next Original] while scanning is in progress.

Table of Contents

Related product manuals