Scanning Procedure
113
The following describes how to store scanned data into a folder as an example.
1 Press the Home button.
2 Select [Store to Folder].
3 If the previous settings still remain, select [Reset].
4 Specify a folder to save the data in.
5 Configure each feature as necessary.
Step 3 Starting the Scan Job
The following describes how to start a scan job.
1 Select [Start].
z
If the document has been loaded in the document feeder, do not hold down the document while it is being
conveyed.
z
If a copy protection code is detected, the device will not scan the document.
z
If a problem occurs, an error message appears on the touch screen. Solve the problem according to the
message.
z
You can set the next job during scanning.
To Next Page
Loading...
