Fuji Xerox ApeosPort-VII C7788 - Page 50

2 Product Overview
50
Reference
z
For more information, refer to "System Settings Procedure" (P.120).
2 Select [System Settings] > [Common Service Settings] > [Power Saver Settings].
3 Select [Power Saver Timers], and then select [Change Settings].
4 Set the time to elapse until entering the Power Saver mode, in 1 minute increments.
From Last Operation to Low Power Mode
Set the time to elapse from the last operation until the device enters the Low Power mode.
Note
z
The default value for [From Last Operation to Low Power Mode] is [1] minute. You cannot disable the Low
Power mode.
From Last Operation to Sleep Mode
Set the time to elapse from the last operation until the device enters the Sleep mode.
Note
z
The default value for [From Last Operation to Sleep Mode] is [40] minute. To make the device enter the Low
Power mode, set a longer period of time for [From Last Operation to Sleep Mode] than for [From Last
Operation to Low Power Mode].
5 Select [Save].
6 Select [Close] repeatedly until the [Tools] screen is displayed.
7 Select [X].