Fax Procedure
155
Fax
4
Step 4 Starting the Fax Job
The following describes how to start a fax job.
1 Press the <Start> button.
Important • If the document has been loaded in the
document feeder, do not hold down the
document while it is being conveyed.
Note • Depending on the settings, the screen to
re-enter the recipient may be displayed
after pressing the <Start> button. In this
case, re-enter the recipient.
• If a problem occurs, an error message
appears on the touch screen. Solve the
problem according to the message.
If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set
of data.
2 While documents are being scanned, select
[Next Original].
Note • When using the document feeder, load
the next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no
operation is performed during a certain
period of time, the machine automatically
assumes that there are no more documents.
• You can change the scan settings of the
next document by selecting [Resolution],
[Original Size], and [Lighten/Darken] that
are displayed after selecting [Next
Original].
3 Load the next document.
4 Press the <Start> button.
If you have more documents, repeat steps 3 and 4.
5 When all documents have been scanned,
select [Last Original].
123
456
789
0#
C
<Start> button
To Next Page
Loading...
