1 Before Using the Machine
24
Before Using the Machine
1
3) Open the front cover.
4) Press the main power switch to the [ ]
position to switch the main power off.
5) Press the <RESET> button. The button
will be depressed even after the pushing
force is released.
6) Press the <TEST> button lightly with a
sharp edge such as a pen tip. The
depressed <RESET> button will stick out
again. This is the end of the check
procedure.
7) Press the <RESET> button back to the depressed position.
If the circuit does not work properly, contact your local Fuji Xerox
representative.
Do not attempt to remove a paper jammed deeply inside the product,
particularly a paper wrapped around a fuser or a heat roller. Otherwise, it may
cause injuries or burns. Switch off the power and then the main power inside
the body front cover promptly and contact your local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
<RESET> button
<TEST> button
To Next Page
Loading...
Need help?
General
