Connectivity
109
CentreWare Internet Services
7
on Devices (WSD)). For IPPS, you can use 443 (HTTPS), and cannot use 80 (HTTPS) or a well-known port
(HTTPS).
TBCP Filter
Select this to enable TBCP filter for PostScript data. When the transmission data includes
binary data or EPS data, disable this.
Password Required
Select this to authenticate with a password.
Connection Timeout
Select this to set the timeout.
Timeout
Sets the connection time-out period.
Spool
Select [On] to enable spooling.
IPsec
Configure the IPsec settings.
For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS], consult your network administrator.
Enable Select whether or not to enable IPsec
communications.
IKE Authentication Method Set the IKE authentication method. Select from
[Digital Signature] or [Preshared Key].
Preshared Key Enter a preshared key. This setting is valid when
[IKE Authentication Method] is set to
[Preshared Key].
Retype Preshared Key Re-enter the preshared key for confirmation.
Device Certificate Select a certificate for IPsec communications.
Select a certificate when [IKE Authentication
Method] is set to [Digital Signature]. A self-
signed certificate created by CentreWare
Internet Services cannot be used.
IKE SA Lifetime Specify IKE SA lifetime from 5 to 28800
minutes in 1 minute increments.
The value must be equal to or greater than the
value set in [IPsec SA Lifetime].
IPsec SA Lifetime Specify IPSec SA lifetime from 300 to 172800
seconds in 1 second increments.
The value must be equal to or smaller than the
value set in [IKE SA Lifetime].
DH Group Set DH group. Select from [G1], [G2], and [G14].
PFS Select whether or not to enable PFS.