Getting started
Settingupthedevice
Workstati onErgonomicDevice
When installing your device, please read the reco mmendations and safety
notes in the "Safety/regulations" manual.
We recommend that you place your de vice on a surf a ce which is not slippery. In
view of the many different finishes and varnishes used on furniture, it is possible
that the rubb er feet will mark the surface they stand on.
Depending on the location of your device, troublesome vibrations and noises
may occur. To prevent th is, a distance of at least 10 mm should be maintained
from other devices on casing sides without ventilation su rfaces.
In order to avoid overheating, do not cover the ve ntilation areas
of the monitor or the device.
A minimum distance of 200 mm from the device m ust be ob served for ven tilation areas.
Do not stack seve ral devices on top of each other.
Do not expose the device to extreme ambient conditions (see "
Technical data", Page 63,
section "Ambient conditions"). Protect the d evice against dust, h umidity and heat.
Connecting the machine to the mains
Mainsadapt er,
2
1
► Connect the mains cable to the machine (1).
► Plug th
e mains plug into a three-pin socket (2).
After
the m ains power cable has been attached, the device automatically switches
itsel
f on for a few seconds to run a system test, then switches off again.
Fujitsu Technology Solutions 13
To Next Page
Loading...
