System expansions
1
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction of the
arrow (1). Ensure that the label on the 3½" hard disk drive is facing the side cover to be opened.
If you are installing a 2½" hard disk drive , ensure that the label is on the top.
► Connect the cables to the hard disk drive.
► R eattach the protective grille (see "
Secur ing the protective grille", Page 56).
► Reattach the hard disk front panel to the casing (see "
Secu ring the
hard disk front panel", Page 56).
► Close the casing (see "
Closing the casing", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
Removing a hard disk
The principles for installing/removing hard disks for the device as described below are identical
for all types of hard disk. Only the size and alignment of the hard disk in the casing may
vary (install either horizontally or vertically depending on the hard disk type).
The following images illustrate the installation of a 3
1
/
2
"drive.
Removingtheharddiskdrive
► Open the casing (see "O pening the casing", Pag e 35).
► Remove the hard disk front panel (see "
Removing the hard disk front pan el", Page 52).
► R emove the protective grille (see "
Removing the pro tective grille", Page 53).
► Disconnect the cables connected to the hard disk drive.
54 Fujitsu Technology Solutions
To Next Page
Loading...
