System expan sio ns
Removing a module holder with reader
► Open the casing (see "O pening t he casing", Page 35).
► Disconnect t he cables connected to the m odule holder.
1
1
2
► Remove the screws ( 1).
► Slide the module holder out of the casing in the direction of the arrow (2).
► Remove the re ader from the module holder (see "
Removing the re ader from
the module holder", Page 43) and reinstall the module holder (corresp onds to
"
Installing a module holder with r eader", Page 42).
or
► Remove the rea
der from the m odule holder (see "
Removing the reader from the
module holde
r", Page 43) and install a blind cover in the drive bay.
► Close the casing (see "
Closing the casing", Page 36).
Removing the reader fro m the module holder
1
1
► Undo the screws (1).
► Pull the r eader out of the module holder
in the direction of the arrow.
Fujitsu Technology Solutions 43
To Next Page
Loading...
