Fujitsu DL3100 User Manual

FUJITSU DL3100
User’s Manual 5-11
* The following options can only be set when carrying the Parallel interface
Interface setup
Valid Settings
Function
Interface
Share,LPT,USB
Share: Printer can detect the type of input
signal and activate USB port or LPT port
automatically.
LPT: Printer can only use LPT port.
USB: Printer can only use USB port.
LPT Initial
NO,Yes
NO: Receive Initial, printer does not reset.
Yes: Receive Initial, printer reset.
LPT ACK Ctrl
Type 1, Type 2, Type
3, Type 4, Type 5
The parameter chooses the width of parallel
interface ACK signal.
LPT STORBE
Ctrl
Rising,Falling
Rising: Rising edge is valid.
Falling: Falling edge is valid.
LPT BI Model
SPP,NIBBlE
SPP: LPT Bidirectional mode is SPP.
NIBBLE: LPT Bidirectional mode is NIBBLE
* The following options can only be set when carrying the Ethernet interface
Interface setup
Valid Settings
Function
Interface
Share,USB,Ethernet
Share: Printer can detect the type of input
signal and activate USB port or LAN port
automatically.
USB: Printer can only use USB port.
Ethernet: Printer can only use LAN port.
DHCP
Disable,Enable
Turn on or turn off DHCP, Disable indicates
turn off, Enable indicates turn on
IP Addr
0.0.0.0
Printer IP address, IP address can be changed if
required
Mask
255.255.255.0
Subnet Mask
Gate
0.0.0.0
Default Gateway

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English