FUJITSU DL3100
User’s Manual 2-5
INSTALL THE
SINGLE SHEET
FEEDER
Install the single sheet feeder into the rear of the printer. If
you intend to use this paper way, assure having removed the
fanfold paper out of the rear tractor paper way by pressing
[Load/Eject]Key.
Then switch the paper select lever to Single.
As shown in the picture below, unfold the Paper Guides first.
Then Tilt the sheet feeder slightly and push it to the
corresponding positioning slot on both sides of the printer
until it can no longer move forward.
To Next Page
Loading...
