Fujitsu DL3100 - Customize Cut Sheet Form Length

FUJITSU DL3100
6-2 User’s Manual
CUSTOMIZE
CUT SHEET
FORM
LENGTH
1. Hold down both the [Online] and [Load/Eject] keys while
powering on the printer and then release the keys when the
carriage initializes and beeps once. After loading a form the
printer prompts:
Customize Form
[LF]=Next, [TEAR]=Back, [LOAD/EJECT]=OK, [ONLINE]=Exit,
[ONLINE]+[LOAD/EJECT]=Save and restart the printer.
Single sheet
2.
Press “OK” to start customizing all or part of 4 parameters for
single sheet. The printer prompts:
[Single sheet]
Form Length
3. You may skip to other customized settings by pressing “Next” or
“Back”. Once you press “OK” to continue with form length
measurement, the printer prompts:
A. Press any key to clear the Setup Instructions Page from the printer.
Insert the Customized Page into the corresponding paper path.
Press[Load/Eject] to load and measure the page length.
B. The printer rolls over the entire Customized Page to measure its length.
After measurement, press [Load/Eject] to load a blank Setup
Instructions Page to report the measured value.
C. Press [Load/Eject] to save the measured value.
Repeat the above steps if the printed value is dissatisfactory.