Fujitsu DL3100 - Online State

FUJITSU DL3100
4-8 User’s Manual
ONLINE STATE
Function
Name
Switch
Operation
LED Function Description
Tear Off {S1}
L2, L3
flash
This is valid for tractor mode only. It feeds the form
to the tear-off position. After tearing off the form,
printing starts on the next TOF by pressing any key
or receiving print data from the host.
LF {S2}
--
Feeds one line with every press of S2
FF [S2]
--
Pressing this key will feed paper one line forward.
By holding down this key, the printer will initially
feed a few lines, then perform a form feed
(continuous paper mode) or eject the form (single
sheet mode).
Load/Eject {S3}
--
Load: Automatically loads the paper (according to
path selection) when no paper is on the platen.
Eject: For rear tractor, it retracts the form from the
platen to allow users to install cut sheets. (NOTE:
Users have to toggle the path selection le
ver.) For cut
sheets, it ejects the form on the platen.
Online {S4}
L4 on
or off
Toggles between Online(L4 on) and Offline
states(L4 off).
Setup State [S4]
L4 flash
Hold the S4 key for 3 seconds. Toggles to 3s Setup
state. Indicated by flashing L4.
Clear Buffer
and Reset
[S4]+{S1}
--
Clears the print buffer. Beeps once upon completion.
Pressing S1 longer initializes the printer to default
settings. Beeps 3 times upon completion.