System expan sio ns
Installing an accessible 5
1
/
4
inch drive (e.g. DVD drive)
► Open the c asing (see "Openin g the casing", Page 32).
Acce ssib ledri ve,Drive,
► If a slide-in m odule is fitted, remove this first. To do this, proceed in the s ame way as when
removing a drive (see "
Removing an accessible 5
1
/
4
inch drive (e.g. DVD drive)", Pag e 38).
Do not d ispose of the empty slide-in module. For cooling, protection against
fire, an d in order to comply with EMC regulations, you must refit the empty
slide-in module if you remove the drive again later.
► Take the new drive out of its packaging.
► Make the desire d settings on the new drive (if necessary, to the settings of
drives already installed as well (Master/Slave)).
1
2
2
► Slide the drive into the casing (1). Make sure that the screw holes are aligned.
► Fasten the drive in place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the casing (see "
Closing the casing", Page 33).
It may be necessary to modify the entry for the drive in the BIOS Setup.
Fujitsu Technology Solutions 39
To Next Page
Loading...
