System expansio ns
Installing an accessible 5
1
/
4
inch drive (e.g. DVD drive)
► Op en the casing (see "Opening the casing", Page 32).
Acces sible driv e,Drive,
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as when
removing a drive (see "
Removing an acces sible 5
1
/
4
inch drive (e.g. DVD drive)", Pag e 38).
Do not dispose of the empty slide-in module. For cooling, pro tect ion against
fire, and in order to comply with EMC regulations, you must refit the empty
slide-in module if you remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of
drives already installed as well (Master/Slave)).
1
2
2
► Slide the d
rive into the casing (1). Make sure that the screw holes are aligned.
► Fasten the drive in place with the screws (2).
► Plug the d
ata and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the c asing (see "
Closing the casing", Page 33).
It may be necessary t o modify the entry for the drive in the B IOS Setup.
Fujitsu Technology Solutions 39
To Next Page
Loading...
