2.2 Function Specifications
This section contains the specifications of the functions for the ETERNUS DX.
Table 2.2 Function Specifications (
ETERNUS DX60 S3)
Item ETERNUS DX60 S3
Supported RAID levels 0 (*1), 1, 1+0, 5, 5+0, 6, 6-FR (*2)
RAID groups Number of RAID groups (max.) (*3) 12
Number of volumes per RAID group 128
Volumes Number of volumes (max.) 1,024
Volume capacity (max.) 128TB
Number of connectable SAN hosts
(HBAs) (max.)
Per storage system 128
Per port 32
*1: Use of RAID0 is not recommended because it is not redundant. For RAID0 configurations, data may be
lost due to the failure of a drive.
*2: Fujitsu original RAID level that provides the high speed rebuild function, and striping with double dis-
tributed parity.
*3: The maximum number of RAID groups that can be registered (for the RAID1 configuration).
2.3 Operating Environment
This section explains the operating environment that is required for the ETERNUS DX operation.
2.3.1 Supported OSs
Servers and OSs that are supported by the ETERNUS DX as a SAN host are shown below.
For details on servers, Host Bus Adapters (HBAs), and driver software combined, refer to "Configuration Guide
-Server Connection-".
Chapter 2 Specifications
2.2 Function Specifications
17
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Overview
Copyright 2014 FUJITSU LIMITED
P3AM-8972-01ENZ0
To Next Page
Loading...
