Fujitsu ETERNUS DX60 S3 - Device Time Synchronization; Figure 3.13 Device Time Synchronization

3.6.4 Device Time Synchronization
The ETERNUS DX has a clock function and manages time information of date/time and the time zone (the
region in which the ETERNUS DX is installed). This time information is used for internal logs and for functions
such as Eco-mode and remote support.
The automatic time correction by the Network Time Protocol (NTP) is recommended to synchronize time in
the whole system.
When using the NTP, specify the NTP server or the SNTP server. The time correction mode is Step mode (im-
mediate correction). The time is regularly corrected every three hours once the NTP is set.
Figure 3.13 Device Time Synchronization
NTP server
ETERNUS DX
Daylight Saving Time
Date and Time
Time Zone
yyyy mm
dd xx:xx:xx
GMT + 09.00
NTP
Chapter 3 Functions
3.6 Operation Management
38
FUJITSU Storage ETERNUS DX60 S3 Disk storage system
Overview
Copyright 2014 FUJITSU LIMITED
P3AM-8972-01ENZ0