Fujitsu Eternus DX80 S2 - Page 114

Chapter 5 Setup
5.1 Basic Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
114
The procedure to create a CA port group is as follows:
Procedure
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the
[Connectivity] screen, click "Port Group" in [Category].
The [CA Port Group] screen appears.
2 In [Action], click one of the following items.
• To create an FC port group, select "Create FC Port Group"
• To create an iSCSI port group, select "Create iSCSI Port Group"
• To create a SAS port group, select "Create SAS Port Group"
• To create an FCoE port group, select "Create FCoE Port Group"
The [Modify Port Mode] screen appears.
3 In the CA port group creation screen, enter the name of the CA port group that is to be
created, select the checkbox for the ports that are to be registered in the CA port group, and
click the [Create] button.
The following example shows the [Create FC Port Group] screen.
A confirmation screen appears.
4 Click the [OK] button.
The CA port group is created and the setting completion screen appears.
5 Click the [Done] button.
The screen display returns to the [CA Port Group] screen.
End of procedure