Chapter 5 Setup
5.1 Basic Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
117
3 Select the "Host Group", the "CA Port Group", and the "LUN Group" that are to be associated.
3-1 Click the [Browse] button in "Host Group".
A screen to select the host group appears.
3-2 Select the connection target from "Host Group" or "All" in "Target Connection".
- When "Host Group" is selected
Select a host group to be associated with a host affinity, and click the [OK] button.
- When "All" is selected
Select a host response, and click the [OK] button.
3-3 Click the [Browse] button in "CA Port Group".
A screen to select the CA port group appears.
3-4 Select the CA port group that is to be associated and click the [OK] button.
The name of the selected CA port group is displayed in "CA Port Group".
3-5 Click the [Browse] button in "LUN Group".
A screen to select the LUN group appears.
3-6 Select the LUN group that is to be associated and click the [OK] button.
The name of the selected LUN group is displayed in "LUN Group".
4 Check the path between the host and the host interface port on the ETERNUS DX Disk
storage system in [Host - CA Port Connection], and click the [Create] button.
A confirmation screen appears.
5 Click the [OK] button.
The host affinity is created and the registration completion screen appears.
To allow all of the hosts to recognize the LUN group, select "All" for "Target Connection".
To Next Page
Loading...
