Fujitsu fi-6110 - Images Are Distorted or Not Clear

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
110
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
Images are distorted or not clear.
Are the glasses and rollers inside the ADF clean?
No
Clean the glasses and rollers inside the ADF.
For details, refer to "Chapter 6 Daily Care" (page 85).
Ye s
Is the ADF being pushed down during scanning? Is there a
heavy object on top of the ADF?
Ye s
Do not push down the top the ADF, or place any heavy objects on the ADF during
scanning.
No
Is anything causing the scanner to vibrate during
scanning?
Ye s
Do not allow the scanner to vibrate during scanning.
No
Is the scanner placed on a flat, level surface? Are the
rubber pads attached on the bottom of the scanner?
No
Either place the scanner on a flat and level surface, or attach the rubber pads on
the bottom of the scanner.
Ye s
If the problem persists, check the items in "8.4 Before You Contact the Scanner
Service Provider" (page 121) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.