Fujitsu fi-6110 - A Shadow Appears at the Top or the Bottom of the Scanned Image

Appendix
Chapter 8 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
118
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
A shadow appears at the top or the bottom of the
scanned image.
Have you adjusted the offset (the position to start the
scan)?
No
Go to [Device Setting] of the Software Operation Panel, and adjust the offset in the
sub-scanning direction.
For details, refer to "Adjusting the Start Position for Scanning [Offset/Vertical
magnification Adjustment]" (page 140).
Ye s
Did you use the Page Edge Filler function?
No
Go to [Device Setting 2] of the Software Operation Panel, and use the Page Edge
Filler function to fill out the shadow around the edge.
For details, refer to "Removing Shadows/Streaks that Appear around the Scanned
Image [Page Edge Filler (ADF)]" (page 142).
Ye s
If the problem persists, check the items in "8.4 Before You Contact the Scanner
Service Provider" (page 121) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.