Fujitsu fi-6110 - Chapter 7 Replacing Consumables

Appendix
Glossary
Introduction
Index
Contents
TOP
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
Chapter 7 Replacing the Consumables
This chapter describes how to replace the consumables for the scanner.
7.1 Consumables and Replacement Cycles.....................................................................................................92
7.2 Replacing the Pad Assy..............................................................................................................................93
7.3 Replacing the Pick Roller ...........................................................................................................................94
7.4 Purchasing the Carrier Sheet .....................................................................................................................98
z The glasses inside the ADF become very hot
when the scanner is being used.
z Before you replace the consumables, make sure
to turn off the power, unplug the power cable
and wait at least 15 minutes for the glass to cool
down.