Fujitsu fi-6110 - Settings Related to Waiting Time; Various Ways to Scan; Waiting Time to Enter Power Saving Mode [Power Saving]

Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
151
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time to Enter Power Saving Mode
[Power saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 125).
2 From the listing on the left, select [Device Setting].
3 Use the slide bar to specify the waiting time before
entering power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
9.7 Settings Related to Waiting Time