Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
133
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Item Description Parameter/Value Factory Default
Page Counter Check the counters to determine when to replace
the consumables.
Also use it to reset the counters after replacing the
consumables.
Total Page Count (ADF) / Pad / Pick Roller 0
Power saving Specify the waiting time before entering power
saving mode.
Range: 5 to 235 min. (in increments of 5) 15 min.
Offset Setting Adjust the position to start the scan on the selected
scanning side(s).
Unit: ADF(Front) / ADF(Back)
Main/Sub/End of page: -2 to +2 mm
(in increments of 0.5)
Main/Sub/
End of page: 0
mm
Vertical magnification
Adjustment
Adjust the magnification level in feed direction for
the selected scanning method.
Unit: ADF
Range: -3.1 to 3.1% (in increments of 0.1)
0%
To Next Page
Loading...
