Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
141
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
3 Adjust the level of offset/vertical magnification as needed.
Offset Setting Description
Unit Select [ADF (front)] or [ADF (back)] as the
target for offset adjustment.
Main Adjusts the horizontal (width) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Sub Adjusts the vertical (length) offset from the top
of the page.
The value can range from -2 to +2 mm (in
increments of 0.5).
End of page Adjusts the vertical (length) offset from the
bottom of the page.
The value can range from -2 to +2 mm (in
increments of 0.5).
Vertical
magnification
Adjustment
Description
Unit The target for vertical magnification
adjustment is fixed to [ADF].
Ver tical
magnification
Adjustment (length)
Adjusts the vertical (length) magnification.
The value can range from -3.1 to +3.1% (in
increments of 0.1).
To Next Page
Loading...
