Chapter 7 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
96
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
9 Attach the shaft.
Insert the right end of the shaft into the bushing (right), and set the
shaft into the slot gradually by lowering it.
10 Secure the bushing (left).
11 Attach the sheet guide.
Hold the pickup tabs on both ends of the sheet guide and place it
back in its original position.
The pickup tabs will lock in place with a clicking sound.
12 Close the ADF.
For details, refer to"1.4 Opening/Closing the ADF" (page 19).
Confirm that the shaft is installed properly. Otherwise, it
may cause feeding errors such as paper jams.
Confirm that the sheet guide is installed properly.
Otherwise, it may cause feeding errors such as paper
jams.
Be careful not to have your fingers caught
when the ADF closes.
To Next Page
Loading...
