Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
121
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
11 Install the new pick roller in the side closer to you.
1 Insert the protrusion (× 2) on the scanner into the hole (× 2) on the
pick roller.
2 Slide the bushing on the left shaft in the direction of the arrow.
3 Fit the protrusion on the right shaft into the notch on the pick roller
and slide the bushing on the right shaft in the direction of the arrow.
4 Rotate the bushing (× 2) on the shaft in the direction of the arrow.
Pick Roller
Protrusions
Holes
Bushing
Shaft
Notch
Protrusion
To Next Page
Loading...
