Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
122
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
12 Close the sheet guide.
Make sure that both ends of the sheet guide are locked firmly.
13 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 24).
14 Plug in the power cable and turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page 23).
15 Reset the pick roller counter.
Reset the counter by performing one of the following actions:
Reset the counter in [4: Consumable counters] on the [Settings
Menu] screen of the operator panel.
For details, refer to "3.2 Settings Menu" (page 62).
Reset the counter in the Software Operation Panel.
For details, refer to "Resetting the Sheet Counters" (page 174).
ATTENTION
Confirm that the pick rollers are installed properly. Otherwise, it
may cause feeding errors such as paper jams.
Be careful not to get your fingers caught
when closing the ADF.
To Next Page
Loading...
