How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
64
How to Load
Documents
Scanner
Overview
Operational settings You can configure various settings for operating the
scanner and using the operator panel.
For more details, refer to "Operational Settings" (page
69).
15: Pick pressure - Yes
16: Manual/Continuous Feed
Setting
-Yes
17: Manual Feed Timeout - Yes
18: Paper Protection - Yes
19: Vertical streak detection - Yes
20: Prioritize panel settings - Yes
21: Ope. Panel Initialization - Yes
22: Power saving - Yes
23: Power-off time - Yes
24: Pre-pick - Yes
25: Overscan Control - Yes
Cleaning the scanner You can clean the scanner by using Cleaning Paper,
Cleaning Wipe, or cloth.
For more details, refer to "Chapter 5 Daily Care" (page
102).
2: Cleaning Yes Yes
Test print for Imprinter You can run a test print when the imprinter is installed.
For more details, refer to the fi-760PRB Imprinter
Operator's Guide.
3: Test Print Yes Yes
Checking and resetting
the sheet counter
You can check the replacement cycle of the
consumables and the total page count.
Also use it to reset the counter when you have
replaced the consumables or performed cleaning.
For more details, refer to "Checking and Resetting the
Sheet Counters" (page 70).
4: Consumable counters Yes Yes
Operation Description Item User
menu
Administrator
menu
Yes: Available
-: Not Available
To Next Page
Loading...
