Fujitsu FI-7600 - Page 77

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
77
How to Load
Documents
Scanner
Overview
18: Paper
Protection
Select a paper protection detection method.
This function can reduce the risk of having the
documents damaged by detecting a feeding error
and stopping the scan in the following cases:
 When the scanner detects a document that was
unusually warped by a feeding error
 When the scanner detects paper jam noise
 When the scanner either detects a document
that was unusually warped by a feeding error or
detects paper jam noise
Specify the sensitivity level to detect anomalies
upon feeding the documents when paper protection
is enabled.
Documents are deformed (for example, warped) or
paper jam noise is made when documents are not
being fed by the rollers properly. To detect such
symptoms and stop the scan, select [1: Low] to only
detect documents that are highly deformed or loud
paper jam noise. To detect documents that are
slightly deformed or small paper jam noise, select
[3: High].
You can also configure the paper protection
detection method from the scanner driver or the
Software Operation Panel. When the operator panel
setting is prioritized, the operator panel setting is
prioritized over the Software Operation Panel
setting. Note that even if the operator panel setting
is prioritized, the scanner driver setting has the
highest priority.
You can also configure the sensitivity level to detect
warped documents and paper jam noise from the
Software Operation Panel. When the operator panel
setting is prioritized, the operator panel setting is
prioritized over the Software Operation Panel
setting.
1: Disable
2: Feeding accuracy
3: Feeding noise
4: Feeding accuracy and noise
Sensitivity for feeding accuracy:
1: Low
2: Normal
3: High
Sensitivity for feeding noise:
1: Low
2: Normal
3: High
2: Feeding
accuracy
Sensitivity
for feeding
accuracy:
2: Normal
Sensitivity
for feeding
noise:
2: Normal
Item Description Parameter (*1)/Value Factory
Default
(*2)
-: No parameters/values