RX200 S3 Options Guide 31
Processors Exchanging the processo
Ê Apply a small amount of thermal paste to the upper side of the new
processor.
Ê Ensure a thin and even distribution of the thermal paste.
Ê Fit the heat sink on the processor such that the airflow arrow labeled is
facing the rear side of the server.(see page 28).
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the air duct. Ensure that the hooks on the air duct (see figure 8 on
page 24) engage on the fan’s rear panel.
Ê Close the server, plug in the power plugs, and switch on the server as
described in the chapter “Completion” on page 41.
To Next Page
Loading...
