RX200 S4 Operating manual 63
Startup and operation Controls and indicators
1 Global Error
Does not light up when the system is OK. No service incident or critical
event has occurred.
Flashes orange when a critical event has occurred. Details of the event
can be found in the BIOS Setup, in the System Event Log or using
ServerView S2. The indicator also flashes in standby mode.
Lights up orange if a prefailure event was detected for a non-CSS
component. Details of the event can be found in the System Event Log or
using ServerView S2. The indicator also lights up in standby mode.
If the event is still acute after a power failure, the indicator is activated after
the restart.
2 ID
Lights up synchronously on the front and rear of the server when the ID
button is pressed.
Lights up blue when the system has been selected by pressing the ID
button. To deactivate, press the button again.
The ID indicator can also be activated via ServerView S2 and its status
reported to ServerView S2.
To Next Page
Loading...
