RX200 S6 Service Supplement 23
4 Replacement routines
V CAUTION!
Observe the safety instructions in the chapter "Safety instructions" on
page 15.
4.1 Opening/closing the server
4.1.1 Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the On/Off
button.
Ê Pull all power cords out of the power outlet.
Ê Disconnect all cables on the rear side of the server.
Ê Loosen the two knurled screws and pull the server as far as possible out of
the rack.
I If the pulled-out server is difficult to access in the rack, remove it
completely from the rack. How to remove the server from the rack is
described in the Operating Manual.
V CAUTION!
At least two people are needed to remove the server from the rack.
(For the Japanese market, please refer to " 安全上の注意およびその他の
重要情報 ".)
To Next Page
Loading...
