RX200 S6 Service Supplement 27
Replacement routines
4.1.4 Closing the server
Ê Position the housing cover so that it protrudes about 1 cm over the rear edge.
Make sure that each bolt is positioned in the corresponding nut.
Ê Push the housing cover forward until it clicks into place.
Ê Insert the fan cover.
Ê Insert the server into the rack (description see the Operating Manual).
V CAUTION!
At least two people are needed to position the server in the rack.
(For the Japanese market, please refer to " 安全上の注意およびその
他の重要情報 ".)
Ê Connect all power plugs to the power outlets and switch on the server.
To Next Page
Loading...
