TX200 S6 Options Guide 39
Main memory
– Memory modules of different capacities may be mixed on a bank by bank
basis (2x2) in the Mirrored Channel Mode and in the Spare Channel Mode.
– The assignment of DIMM slots to the memory banks and channels is
imprinted on the system board.
– Install memory modules within a channel in descending order of capacity:
higher capacity in the black slot; lower capacity in the blue slot.
5.2 Expanding the main memory
Ê Open the server and remove system fan 2 (or 2&4) as described in the
chapter "Preparation" on page 27.
Ê Press the securing clips on both sides of the memory slot concerned
outward.
Figure 11: Expanding the memory module
Ê Carefully press the memory module into the slot (1) until the securing clips
on both sides of it engage (2).
Ê Reinstall system fan 2 (or 2&4) as described in the section "Installing system
fan 2 (or 2&4)" on page 108.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 107.
Ԙ
ԙ
ԙ
To Next Page
Loading...
