How to Perform a Basic Scan
This section explains how to perform a basic scan.
Performing a Scan with an Image Scanning Application
This section explains about the basic flow of performing a scan using an image scanning application on the
computer.
In this case, a scanner driver and an image scanning application that supports the scanner driver must be installed
on the computer.
The following scanner driver and image scanning applications are bundled with the scanner:
● Scanner driver
- PaperStream IP driver
● Image scanning application
- PaperStream Capture
- ABBYY FineReader Sprint
HINT
● For details about the scanner driver and image scanning applications, refer to Overview of the Bundled
Software (page 18).
● Scanning procedures, operations, and scan setting items slightly vary depending on the image scanning
application and the scanner driver.
For details, refer to the help for the image scanning application and the scanner driver.
● Depending on the connection method of the scanner, use only the USB cable to connect to a computer or use
only a LAN cable to connect to a network device. Do not use both cables at the same time.
1 Turn on the scanner.
For details, refer to How to Turn the Power ON (page 31).
2 Load a document in the ADF paper chute (feeder).
39
To Next Page
Loading...
Need help?
General
