Fujitsu SP-1120N User Manual

Replacing the Consumables
This section explains how to replace the consumables for the scanner.
CAUTION
The inside of the ADF becomes very hot when the scanner is being used.
Before you replace the consumables, make sure to turn off the power, unplug the power
cable and wait for at least 15 minutes for the inside of the ADF to cool down.
Consumables and Replacement Cycles
Name Part No. Suggested Replacement Cycle
ROLLER SET
● Brake roller
● Pick roller
PA03708-0001 100,000 sheets or one year
Consumables need to be replaced periodically. It is recommended that you keep a stock of new consumables
and replace them before it reaches the end of the consumable life. Also, the scanner records the number of
sheets scanned, which allows you to determine when to replace the consumables.
For information on how to check the number of sheets scanned, refer to Settings Related to Sheet Counters
(page 135).
Note that the suggested replacement cycles are guidelines for using A4 (80 g/m
2
[20 lb]) wood-free or wood-
containing paper, as these cycles vary depending on the type of documents scanned and how often the scanner
is used and cleaned.
77

Fujitsu SP-1120N Specifications

General

Optical Resolution	600 x 600 dpi
Maximum Document Size	A4
Scan Speed (Color, A4, 300 dpi)	20 ppm
Scan Speed (Mono, A4, 300 dpi)	20 ppm
ADF Capacity	50 sheets
Interface	USB 2.0
Scanning Method	CIS (Contact Image Sensor)
Color Depth	24-bit
Grayscale Depth	8-bit
Scanner Type	ADF (Automatic Document Feeder)
Scanning Speed	20 ppm (pages per minute)
Daily Duty Cycle	3000 pages
Supported OS	Windows
Dimensions	298 x 135 x 133 mm