Fujitsu SP-1120N User Manual

● Load plastic cards one at a time in the ADF paper chute (feeder).
● It is recommended to place the card face-down in the ADF paper chute (feeder).
● Rigid cards may not be fed properly.
● If there is dirt on the surface of the card, such as grease marks (fingerprints), perform scanning after wiping
the dirt off.
● Scanning a thick document such as a plastic card will always be falsely detected as overlapped documents.
In such a case, disable the setting in the image scanning application or scanner driver so that overlapped
documents (multifeeds) are not detected, and then try scanning again.
How to Load Documents
55

Fujitsu SP-1120N Specifications

General

Optical Resolution	600 x 600 dpi
Maximum Document Size	A4
Scan Speed (Color, A4, 300 dpi)	20 ppm
Scan Speed (Mono, A4, 300 dpi)	20 ppm
ADF Capacity	50 sheets
Interface	USB 2.0
Scanning Method	CIS (Contact Image Sensor)
Color Depth	24-bit
Grayscale Depth	8-bit
Scanner Type	ADF (Automatic Document Feeder)
Scanning Speed	20 ppm (pages per minute)
Daily Duty Cycle	3000 pages
Supported OS	Windows
Dimensions	298 x 135 x 133 mm