FCC and IC Regulatory Information
FCC Radio Frequency Exposure statement
The available scientific evidence does n ot show that any health problems are associated with
using low power wireless devices. There is no proof, however, that these low power wireless
devices are absolutely safe. L ow power wireless devices emit low levels of radio frequency
energy (RF) in the microwave range while being used. Whereas high levels of RF can produce
health effects (by heating tissue), exposure to low-level RF that does n ot produce heating
effects causes no known adverse health effects. Many studies of low-level RF exposure have
not found any biological effects. Some studies have suggested that some biological effects
might occur, but such findings ha ve not been confirmed by additional research.
The wireless LAN radio device has been tested and found to comply with FCC radiation
exposure limits set forth for an uncontrolled equipmen t and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65.
The exposure s tandard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FC C is 1.6W/kg, and 1.6W/kg by Indu stry Canada.
This device is compliant with SAR for general population /uncontrolled e xpo sure limits in
ANSI/IEEE C9 5.1-19 92 and Canada RSS 102, and had been te sted in accordance with
the m easurement meth ods and procedures specified in O ET Bulletin 65 S upplement C,
and Canada RSS 10 2. This de vice has been tested, and meets the FCC, IC RF exposure
guidelines when teste d with the device op erating conditions.
Déclaration de la FCC/d’Industrie Canada sur
l’exposition aux radiofréquences
La norme régissant l’exposition des appareils sans fil aux radiofréquences emploie une unité
de mesure dénommée Taux d’absorption spéci fique, ou TAS. La FC C et Industrie Canada ont
défini la même limite de TAS : 1,6 W/kg. Cet appareil est conforme au TAS pour les limites
d’exposition généra les de la population/non contrôlées défi nie s par les règles C95.1-1992 de
l’ANSI/IEEE et RSS 102 d’Industrie Canada ; il a été testé en conformité avec les métho des
et procédures de mesure spécifiées dans le supplément C du bulletin 65 de l’OET (O ffice
d’ingénierie et de technologie) et la règle RSS 102 d’Industrie Canada. Cet appareil a été testé
selon les directives de la FCC et d’IC conce rnant l’exposition aux radiofréquences et s’est révélé
conforme à ces d ernières lorsqu’il a été testé en contact direct avec le corps.
Export restrictions
This product or software contains encryption code which may not be exported or transferred
from the US or C anada without an approved US Department of Commerce export license.
This device complies with Part 15 of FCC Rules., as well as ICES 003 B / NMB 003 B.
Operation is subject to the following tw o conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesirable operation. Modifications n ot expressly authorized by Fujitsu
America, Inc. may invalidate the user’s right to operate this equipment.
98 Fujitsu
To Next Page
Loading...
Need help?
General